Disassembly of the parts (Indoor unit)
Service Manual 59
• Unhook the tab on the right inside of the chassis
at the same time, slightly pull the evaporator
toward you until the tab is clear of the slot.
5. To remove the Motor Cover
• Remove 2 securing screw.
• Pull the motor cover out from the chassis
carefully.
6. To remove the Cross-Flow Fan
• Loosen the screw securing the cross-flow fan to
the fan motor (do not remove).
• Lift up the right side of the cross-flow fan and the
fan motor, separate the fan motor from the cross-
flow fan.
• Remove the left end of the cross-flow fan from
the self-aligning bearing.
Warning :
Disconnect the unit from power supply before making
any checks.
Be sure the power switch is set to “OFF”.
1. To remove the Grille from the Chassis.
- Pull the grille bottom, the remove 2 securing screws.
- Lift the both lower parts of panel front.
- After pull down this panel a bit, separate connecting
wire with product.
2. To remove the Control Box.
- Before removing the control box, be sure to
disconnect the wires from PWB.
- Pull the cover control out from the control box
and disconnect other wires.
- Remove securing screws.
- Pull the control box out from the chassis carefully.
Motor cover
Panel Front
Connector
Step Motor Connectors
Sensor Connector
Comp Connector
4Way/Fan Connector
Motor
Connector
Power Connector
Power Connector
Comp Connector
2. SP1 Chassis
Содержание A2UC146FA0
Страница 28: ...28 Free Joint Multi Air Conditioner Wiring Diagram 5 A3UC216FA0 6 A3UH216FA0 7 A4UC306FA0 8 A4UH306FA0 ...
Страница 32: ...32 Free Joint Multi Air Conditioner Schematic Diagram Schematic Diagram Indoor Unit 1 1 SQ SR ST Chassis ...
Страница 33: ...Service Manual 33 Schematic Diagram 1 2 SP 1 Chassis ...
Страница 78: ...P No 3828A20097X January 2005 Printed in Korea ...