14
ENGLISH
Antenna connection
Connect the TV to a wall antenna socket with an RF cable (75 Ω).
t
Use a signal splitter to use more than 2 TVs.
t
If the image quality is poor, install a signal amplifier properly to
improve the image quality.
t
If the image quality is poor with an antenna connected, try to
realign the antenna in the correct direction.
t
An antenna cable and converter are not supplied.
t
Supported DTV Audio: MPEG, Dolby Digital, Dolby Digital Plus,
HE-AAC
t
For a location that is not supported with ULTRA HD broadcasting,
this TV cannot receive ULTRA HD broadcasts directly. (Depending
on model)
Satellite dish connection
(Only satellite models)
Connect the TV to a satellite dish to a satellite socket with a satellite RF
cable (75 Ω).
CI module connection
(Depending on model)
View the encrypted (pay) services in digital TV mode.
t
Check if the CI module is inserted into the PCMCIA card slot in the
right direction. If the module is not inserted properly, this can
cause damage to the TV and the PCMCIA card slot.
t
If the TV does not display any video and audio when CI+ CAM is
connected, please contact to the Terrestrial/Cable/Satellite Service
Operator.
USB connection
Some USB Hubs may not work. If a USB device connected using a USB
Hub is not detected, connect it to the USB port on the TV directly.
Other connections
Connect your TV to external devices. For the best picture and audio
quality, connect the external device and the TV with the HDMI cable.
Some separate cable is not provided.
t
General
HDMI ULTRA HD Deep
Colour
-
On
: Support 4K @ 50/60 Hz (4:4:4, 4:2:2, 4:2:0)
-
Off
: Support 4K @ 50/60 Hz 8 bit (4:2:0)
If the device connected to Input Port also supports ULTRA HD Deep
Colour, your picture may be clearer. However, if the device doesn’t
support it, it may not work properly. In that case, connect the device
to a different HDMI port or change the TV’s
HDMI ULTRA HD Deep
Colour
setting to
Off
.
(This feature is available on certain models which are supported
ULTRA HD Deep Colour only.)
NOTE
t
Supported HDMI Audio format :
Dolby Digital (32 kHz, 44.1 kHz, 48 kHz),
DTS (44.1 kHz, 48 kHz),
PCM (32 kHz, 44.1 kHz, 48 kHz, 96 kHz, 192 kHz)
(Depending on model)
Remote control
The descriptions in this manual are based on the buttons on the remote
control. Please read this manual carefully and use the TV correctly.
To replace batteries, open the battery cover, replace batteries (1.5
V AAA) matching the
and
ends to the label inside the
compartment, and close the battery cover. To remove the batteries,
perform the installation actions in reverse.
Make sure to point the remote control toward the remote control sensor
on the TV.
(Depending on model)
