3
ENG
ENGLISH
Installation Menu
DPM
y
y
You can configure the DPM (Display Power Management) function.
y
y
Off: you can set this option to Off, 5 sec./10 sec./15 sec./1 min./3 min./5 min./10 min.
y
y
If this option is not set to Off, the monitor set enters the DPM mode when there is no input signal.
y
y
If you set this option to Off, the DPM function is disabled.
y
y
In the following cases, you can set DPM to Off or 10 min only. If DPM was set to 5 sec, 10 sec, 15 sec,
1 min, or 5 min, it will be changed to 10 min.
- When USB Auto Playback is set to Photo or Movie
- When Fail Over is set to Auto or Manual
(Depending on the model, this feature may not be supported.)
Screen Off Select
y
y
Set up Screen Off Select.
y
y
You can turn this option on or off.
y
y
If you turn this option on, the screen turns off and you can only hear sounds when there is no input sig-
nal. If there is an input signal when the screen is off or if you press any button other than the power but-
ton on the remote control, the screen turns back on. If there is no input signal and no buttons pressed
on the remote control after the screen is turned on, the screen turns off after five seconds.
y
y
If you turn this option off, Screen Off Select will be unavailable.
Baudrate (9600/115200)
y
y
You can change the RS-232 communication speed for controlling your monitor.
y
y
You can choose 9600 or 115200.
y
y
If you set this option to 9600, the RS-232 communication speed is set at 9600 bps.
y
y
If you set this option to 115200, the RS-232 communication speed is set at 115200 bps.
(Depending on the model, this feature may not be supported.)
OSD Portrait Mode (Off, On)
y
y
You can rotate the OSD clockwise.
y
y
You can set this option to On or Off.
y
y
If you set this option to Off, the function is deactivated.
y
y
If you set this option to On, the OSD rotates 90 degrees clockwise. In this case, you can not use a
mouse.
y
y
The external input screen and the SuperSign Content playback screen do not rotate even when the
OSD Portrait Mode is set to On.
(Depending on the model, this feature may not be supported.)
Power On Delay (0 ~ 250)
y
y
This feature delays power on in order to prevent overload when multiple monitor sets are turned on
simultaneously.
y
y
You can set the delay interval in the range of 0 to 250 seconds.
Check Screen
y
y
The Check Screen feature judges whether there are abnormalities at the edges of the screen. R, G, and
B OSDs are formed on the screen at one second intervals and an RGB Sensor tests the areas.
y
y
If set to On, the Check Screen feature is enabled.
y
y
If set to Off, the Check Screen feature is disabled.
y
y
When the Portrait mode is On, the Check Screen feature is Off and deactivated.
(Depending on the model, this feature may not be supported.)