ENGLISH
9
t
Antenna Isolator Installation Guide (Depending on model)
-
Use this to install TV in a place where there is a voltage
difference between TV Set and GND of antenna signal.
»
If there is a voltage difference between TV Set and GND of
antenna signal, the antenna contact might be heated and
excessive heat might cause an accident.
-
You can improve the safety when watching TV by efficiently
removing power voltage from TV antenna. It is recommended
to mount the isolator to the wall. If it cannot be mounted to
the wall, mount it on the TV. Avoid disconnecting the antenna
Isolator after installation.
-
Before starting, be sure that the TV antenna is connected.
ANTENNA/
CABLE IN
Wall
Cable /
Antenna
or
Isolator
1. Connect to TV.
2. Connect to Set-Top box.
-
Connect one end of the isolator to cable/antenna jack and the
other to TV set or set-top box.
-
“Equipment connected to the protective earthing of the building
installation through the mains connection or through other
equipment with a connection to protective earthing - and to
a cable distribution system using coaxial cable, may in some
circumstances create a fire hazard. Connection to a cable
distribution system has therefore to be provided through a
device providing electrical isolation below a certain frequency
range (galvanic isolator, see EN 60728-11)”
-
When applying the RF Isolator, a slight loss of signal sensitivity
can occur.
CAUTION
t
Do not use any unapproved items to ensure the safety and product
life span.
t
Any damage or injuries caused by using unapproved items are not
covered by the warranty.
t
Some models have a thin film attached on to the screen and this
must not be removed.
t
When attaching the stand to the TV set, place the screen facing
down on a cushioned table or flat surface to protect the screen
from scratches.
t
Make sure that the screws are inserted correctly and fastened
securely. (If they are not fastened securely enough, the TV may tilt
forward after being installed.) Do not use too much force and over
tighten the screws; otherwise screw may be damaged and not
tighten correctly.
t
Make sure to wring any excess water or cleaner from the cloth.
t
Do not spray water or cleaner directly onto the TV screen.
t
Make sure to spray just enough of water or cleaner onto a dry cloth
to wipe the screen.
t
When cleaning the product, be careful not to allow any liquid or
foreign objects to enter the gap between the upper, left or right
side of the panel and the guide panel. (Depending on model)
Separate purchase
Separate purchase items can be changed or modified for quality
improvement without any notification. Contact your dealer to buy these
items. These devices only work with certain models.
The model name or design may be changed depending on the upgrade
of product functions, manufacturer’s circumstances or policies.
(Depending on model)
AG-F***
Cinema 3D Glasses
AN-MR650
Magic Remote
AN-VC550
Smart camera
AG-F***DP
Dual Play Glasses
