LG 32SM5KC-B, Руководство пользователя, Страница: 33 / 64

33
ENGLISH
PICTURE ID Settings
y
Only applies to certain models.
PICTURE
ID
is used to change the settings of a
specific set (display) using a single IR receiver for
multi-vision. Communication is possible between
a monitor with an IR receiver and other monitors
using RS-232C cables. Each monitor is identified
by a
Set ID
. If you assign the PICTURE
ID
using
the remote control, only displays with matching
PICTURE
ID
and
Set ID
can be controlled
remotely.
1
Assign the Set ID to the installed monitors as
shown below
.
AUDIO
(RGB/DVI)
REMOTE
CONTROL IN
RS-232C OUT
RS-232C IN
RS-232C OUT
RS-232C IN
RS-232C OUT
RS-232C IN
IR & Light Sensor
RS-232C cables
PICTURE ID
2
Press the red ON button on the remote control to
assign the PICTURE ID.
3
Assign the Set ID to the selection of your choice.
y
A set with a different Set ID from the PICTURE
ID cannot be controlled by IR signals.
NOTE
y
If
PICTURE ID
is set to 2, only the upper
right monitor, which has a
Set ID
of 2, can be
controlled by IR signals.
y
If you press the green OFF button for PICTURE
ID , the PICTURE ID s for all monitors are turned
off. If you then press any button on the remote
control, all monitors can be controlled by IR
signals regardless of Set ID .