LG 19LS3300, Руководство по обслуживанию

Страница: 12 / 26

- 12 - LGE Internal Use Only Copyright © LG Electronics. Inc. All rights reserved.
Only for training and service purposes
4.3. Adjustment of White Balance
(for Manual adjustment)
■ Color analyzer(CA100+, CA210) should be used in the
calibrated ch by CS-1000
■ Operate the zero-calibration of the CA100+ or CA-210, then
stick sensor to the module when adjusting.
■ For manual adjustment, it is also possible by the following
sequence.
1) Select white pattern of heat-run by pressing “POWER
ON” key on remote control for adjustment then operate
heat run longer than 5 minutes. (If not executed this
step, the condition for W/B may be different.)
2) Push “Exit” key.
3) Change to the AV mode by remote control.
4) Input external pattern (85% white pattern)
5) Push the ADJ key two times (entering White Balance
mode) → Enter “0413” (Password)
6) Stick the sensor to the center of the screen and select
each items (Red/Green/Blue Gain and Offset) using
▲/▼(CH +/-) key on R/C..
7) Adjust R/ G/ B Gain using ◄/►(VOL +/-) key on R/C.
8) Adjust three modes all (Cool / Medium / Warm) : Fix the
one of R/G/B gain and change the others
9) When adjustment is completed, Exit adjustment mode
using EXIT key on R/C.
* CASE
First adjust the coordinate far away from the target value(x, y).
1) x, y > target
i) Decrease the R, G.
2) x, y < target
i) First decrease the B gain,
ii) Decrease the one of the others.
3) x > target , y < target
i) First decrease B, so make y a little more than the target.
ii) Adjust x value by decreasing the R
4) x < target , y > target
i) First decrease B, so make x a little more than the target.
ii) Adjust x value by decreasing the G
■ Standard color coordinate and temperature when using the
CA100+ or CA210 equipment (Small size inch’s color
coordinate is different from others, So use below table)
1) 22 inch Lamp(CMI & THTF)
To check the Coordinates of White Balance, you have to
measure at the below conditions.
Picture Mode : Vivid(User)
Dynamic Contrast : Off , Dynamic Colour : Off
(If you miss the upper condition, the coordinates of W/B
can be lower than the spec.)
Mode
Color coordinate
Temp ∆uv
x y
Cool 0.271±0.002 0.276±0.002 13,000K 0.000
Medium 0.287±0.002 0.296±0.002 9,300K 0.000
Warm 0.315±0.002 0.332±0.002 6,500K 0.003