To mount the battery pack on a wall, take the following steps :
1. Mark the location on the wall for the holes.
2. Drill holes for fasteners in the wall.
3. Drive the fasteners through the mounting bracket into the holes.
Area 1
Area 3
Area 2
Area 4
At least 250mm
Ex)
Ëh
Recommended diameter :
10mm(0.4") Min.
Ëh
Recommended length :
70mm(2.8") Min.
Ëh
Recommended material :
Stainless steel (8.8T)
Ëh
Recommended fastener count :
Recommended minimum fastener
clearance :
At least 250mm (10")
ex. Between Area 1’s last fastener and
Area 2’s
fi
rst fastener
4(Area1)/2(Area2)/4(Area3)/2(Area4)
- Vertically
Ëh
Installation
19
3.1.6 Mounting bracket
When installing the battery pack on a wall, make sure that the wall is capable of
supporting the weight of the battery pack.
CAUTION
Make sure that the battery pack is at all times exposed to the ambient air.
The battery pack is cooled by natural convection. If the battery pack is entirely or
partially covered or shielded, it may cause the battery pack to stop operating.
