9
STANDARD OR ANGLE MOUNTING INSTRUCTIONS
1. Remove the downrod clip (C) and downrod pin (B) from
the downrod (A). Then partially loosen the set screws
(Q) in the yoke at the top of the motor housing (H).
2. Insert the downrod (A) through the canopy (E) and yoke
cover (J). Thread the wires from the motor assembly
(H) through the downrod (A).
3. Slide the downrod (A) into the yoke of the motor
assembly (H), align the holes, then re-install the
downrod pin (B) and downrod clip (C). Secure with the
two set screws (Q) and slide the yoke cover (J) down
until it rests on top of the motor assembly (H).
A
C
B
Q
A
E
J
H
J
C
H
A
B
Q
H
1
2
3
Yoke
