LEYBOLD 230680V01, Руководство по эксплуатации

Страница: 17 / 20

GA300553102_002_C2
– 04/2017
17
1
In addition to display of the error in place of the measured value, the warning symbol blinks in display
modes Normal or Speedo. The error message is displayed in red font for the display modes Chart, Big and
Leak Test as well as for the other channels in display mode Speedo. The error signal relay toggles according
to the settings.
2
In addition to the measured value, the warning symbol glows in display modes Normal or Speedo. The
error message is displayed in yellow font for the display modes Chart, Big and Leak Test as well as for the
other channels in display mode Speedo.
6.1.2 System Errors
Error description
(Error Log)
Display
(TFT display)
Error number
(Interface)
Cause and remedy
no errror none 0 System works error-free.
Error usb file open none 1 File on USB stick cannot be
opened. Check the attached USB
memory stick.
Error usb folder open none 2 Folder on USB stick cannot be
opened. Check the attached USB
memory stick.
Error usb file closing none 3 File on USB stick cannot be stored.
Check the attached USB memory
stick.
Error usb write none 4 USB stick not recordably. Check
the attached USB memory stick.
Error usb read none 5 USB stick not readably. Check the
attached USB memory stick.
Error read eeprom none 6 EEPROM of the equipment not
readably.
Contact your next
Leybold GmbH service office.
Error write eeprom none 7 EEPROM of system not recordably.
Contact your next Leybold GmbH
service office.
Error init eeprom none 8 EEPROM error of system.
Contact your next Leybold GmbH
service office.
Table 8
–
System errors
6.2 Error Log
The GRAPHIX Controller stores the errors recognized by the system. They have the
possibility of being able to be been noticeable the last 20 errors. Important information on
the display area is represented
(

Fig. 5, page 17).
Fig. 5
–
Error log
A
Error number 1
– 20
(1 = freshest error)
B Date of displayed error
C Time of displayed error
D Error source:
Channel 1 = Sensor error at channel 1
Channel 2 = Sensor error at channel 2
Channel 3 = Sensor error at channel 3
Device = System error
E Error description
(

Table 7, page 16 and Table 8,
page 17)