Lexus RC200t, Руководство пользователя

Страница: 303 / 724

303
4-5. Using the driving support systems
4
Dr
iving
■
Sounds and vibrations caused by the ABS, brake assist, VSC, TRAC, hill-start assist
control and VGRS systems
●
A sound may be heard from the engine compartment when the brake pedal is
depressed repeatedly, when the engine is started or just after the vehicle begins to
move. This sound does not indicate that a malfunction has occurred in any of these sys-
tems.
●
Any of the following conditions may occur when the above systems are operating.
None of these indicates that a malfunction has occurred.
• Vibrations may be felt through the vehicle body and steering.
• A motor sound may be heard after the vehicle comes to a stop.
• The brake pedal may pulsate slightly after the ABS is activated.
• The brake pedal may move down slightly after the ABS is activated.
■
EPS, VGRS and DRS operation sound
When the steering wheel is operated, a motor sound may be heard. This does not indi-
cate a malfunction.
■
Reactivation of the TRAC/VSC systems
Even after the TRAC/VSC systems have been turned off, turning the engine off and then
on again will automatically reactivate the TRAC/VSC systems.
■
Reactivation of the TRAC system linked to vehicle speed
When only the TRAC system is turned off, the TRAC system will turn on when vehicle
speed increases. However, when both TRAC/VSC systems are turned off, the systems
will not turn on even when vehicle speed increases.
■
Reduced effectiveness of the EPS system
The effectiveness of the EPS system is reduced to prevent the system from overheating
when there is frequent steering input over an extended period of time. The steering
wheel may feel heavy as a result. Should this occur, refrain from excessive steering input
or stop the vehicle and turn the engine off. The EPS system should return to normal
within 10 minutes.
■
Operating conditions of hill-start assist control
When the following four conditions are met, the hill-start assist control will operate:
●
The shift lever is in a position other than P or N (when starting off forward/backward on
an upward incline).
●
The vehicle is stopped.
●
The accelerator pedal is not depressed.
●
The parking brake is not engaged.
■
Automatic system cancelation of hill-start assist control
The hill-start assist control will turn off in any of the following situations:
●
The shift lever is moved to P or N.
●
The accelerator pedal is depressed.
●
The parking brake is engaged.
●
Approximately 2 seconds elapse after the brake pedal is released.