Lexus RC 300 2019, Руководство пользователя

Страница: 378 / 475

376 7-2. Steps to take in an emergency
WARNING
●
After inflation of the tire has com-
pleted, the sealant may splatter when
the hose is disconnected or some air is
let out of the tire.
●
Follow the operation procedure to
repair the tire. If the procedure is not
followed, the sealant may spray out.
●
Keep back from the tire while it is
being repaired, as there is a chance of
it bursting while the repair operation is
being performed. If you notice any
cracks or deformation of the tire, turn
off the compressor switch and stop the
repair operation immediately.
●
The kit may overheat if operated for a
long period of time. Do not operate
the compressor continuously for more
than 35 minutes.
●
Parts of the kit become hot during
operation. Be careful handling the kit
during and after operation. Do not
touch the metal part around the con-
necting area between the bottle and
compressor. It will be extremely hot.
●
Do not attach the vehicle speed warn-
ing sticker to an area other than the
one indicated. If the sticker is attached
to an area where an SRS airbag is
located, such as the pad of the steering
wheel, it may prevent the SRS airbag
from operating properly.
■
Driving to spread the liquid sealant
evenly
Observe the following precautions to
reduce the risk of accidents.
Failing to do so may result in a loss of
vehicle control and cause death or seri-
ous injury.
●
Drive the vehicle carefully at a low
speed. Be especially careful when
turning and cornering.
●
If the vehicle does not drive straight or
you feel a pull through the steering
wheel, stop the vehicle and check the
following:
• Tire condition. The tire may have sepa-
rated from the wheel.
• Tire inflation pressure. If tire inflation
pressure is 130 kPa (1.3 kgf/cm
2
or bar,
19 psi) or below, this may indicate
severe tire damage.
NOTICE
■
When performing an emergency
repair
●
Perform the emergency repair with-
out removing the nail or screw that has
punctured the tread of the tire. If the
object that has punctured the tire is
removed, repair by the emergency tire
puncture repair kit may not be possi-
ble.
●
The kit is not waterproof. Make sure
that the kit is not exposed to water,
such as when it is being used in the
rain.
●
Do not put the kit directly onto dusty
ground such as sand at the side of the
road. If the kit vacuums up dust etc., a
malfunction may occur.
●
Make sure to stand the kit with the bot-
tle vertical. The kit cannot work prop-
erly if it is laid on its side.
■
Handling the emergency tire punc-
ture repair kit
●
The compressor power source should
be 12 V DC suitable for vehicle use.
Do not connect the compressor to any
other source.
●
If gasoline splatters on the kit, the kit
may deteriorate. Take care not to allow
gasoline to contact it.
RC350-RC300_OM_General_OM24884E