Lexmark X95x, Руководство по обслуживанию

Страница: 823 / 1153

Repair information
4-349
7558- xxx
Go Back
Previous
Next
Finisher media entrance roll assembly removal
1. Remove the finisher front door assembly. See
“Finisher front door assembly removal” on page 4-345
.
2. Remove the rear upper cover. See
“Rear upper cover removal” on page 4-377
.
3. Remove the left upper cover. See
“Left upper cover removal” on page 4-357
.
4. Remove the punch waste box (A) from the finisher.
5. Remove the screw securing the cover (B) to the media entrance pinch guide assembly.
6. Remove the cover (B).
7. Lift the media entrance pinch guide assembly (C).
8. Loosen the two screws securing the belt tensioner bracket (D) to the finisher and move it upward in the
direction of the arrow.
9.
Remove the belt (entrance/paddle) (E) from the entrance drive pulley 20T (F).
10.
Release the hook securing the entrance drive gear 23T (G) to the media entrance roll assembly (H).
11.
Remove the entrance drive gear 23T (G).
12.
Remove the entrance drive pulley 20T (F).
13.
Remove the bushing (I).
14.
Remove the e-clip securing the media entrance roll assembly (H) to the front of the finisher.
15.
Remove the bushing (J).
16. Move the media entrance roll assembly (H) toward the rear, downward, and then forward.
17. Remove the media entrance roll assembly (H) through the inside of the finisher.
Note:
When removing the media entrance roll assembly (H), do not touch the rubber surface.
First
Second
D
E
D
C
B
A
Front
G
F
I
H
Rear
H
J
E-clip
Front