Lexmark 7462 series, Руководство по обслуживанию, Страница: 283 / 729

ADF Edge Erase
This setting sets the size of the no-print area around an ADF scan job.
1
Enter the Configuration menu, and then select ADF Edge Erase .
2
Select a setting.
3
Apply the changes.
FB Edge Erase
This setting sets the size of the no
‑
print area around a flatbed scan job.
1
Enter the Configuration menu, and then select FB Edge Erase .
2
Select a setting.
3
Apply the changes.
Scanner Manual Registration
Use this setting to register the flatbed and ADF on the scanner. Perform a registration adjustment whenever
the ADF, flatbed, or controller board is replaced.
Note: This setting does not appear if the Disable Scanner setting is set to Auto Disabled.
Enter the Configuration menu, and then select Scanner Manual Registration .
Flatbed registration adjustment
1
Enter the Configuration Menu, and then navigate to:
Scanner Manual Registration > Print Quick Test
2
Remove all the pages from the ADF, place the Quick Test page on the flatbed, and then select Copy Quick
Test .
Do this step to view the current flatbed registration values.
3
Select Flatbed .
The current values of the left margin and top margin registration settings appear.
4
Adjust the left and top margins.
5
Apply the changes.
6
Repeat step 2 to view the updated values.
7
Repeat steps 3 through 5 to make further adjustments.
ADF registration adjustment
1
Enter the Configuration Menu, and then navigate to:
Scanner Manual Registration > Print Quick Test
2
Place the Quick Tests page on the ADF and then select Copy Quick Test .
Do this step to view the current ADF registration values.
7462
Service menus
283