Lexmark 5056-000, Руководство по обслуживанию

Страница: 111 / 366

Diagnostic information
2-69
5056- XXX
This service check is the same as the flash memory option service check with the following exception:
Run the “DRAM Test” on page 3-10 from the menu if the DRAM Memory card assembly is correctly installed
and not broken or damaged. If the test fails, replace the DRAM card assembly. If the problem continues, replace
the RIP board.
Hard Disk Option
Service Tip: The 5056-01 x printers support one hard disk option. Be sure only one 3.2 GB or larger hard disk
option is installed. Be sure the hard disk and the hard disk board are correctly installed. Run the “Quick Disk
Test” on page 3-16 from the Device Test on the Diagnostic Menu when a problem is suspected either with the
hard disk system board or with the hard disk.
Note: The Quick Disk Test is a non-destructive test and indicates Pass or Fail. If the test fails, replace the hard
disk. If a problem still exists, replace the hard disk board.
Use the “Disk Test/Clean” on page 3-16 to help restore the disk if it contains bad data and is unusable. This
test is divided into a cleaning and a verifying or testing section.
Warning: This can be a very lengthy test depending on the disk size. This test leaves the hard disk
unformatted. The servicer or user must reformat the disk using the Format Disk Menu operation.
This is a destructive type of test. All the data on the disk is destroyed and should not be performed
on a known good disk.
Network Card Option
The network is installed on the system board on network model printers.
Error Code 976 - Network Card x
A 976 error code indicates an unrecoverable software error in network card x . Verify that network card x is
correctly installed in the socket on the interconnect board and is properly grounded. If you find no problem,
contact your next level of support before replacing the network card.
54 Network < x > Software Error
This error displays when the RIP software detects that a network card is installed in slot x on the interconnect
board but cannot establish communications with the network card.