www.lexing.com.cn
Stand Alone Smoke Alarms
R
LX-SO-98D
*Hammer
1. Hold base firmly and push the hinge in then turn anti-clockwise,so release the base
down.
2. Hold the smoke alarm base against the ceiling(or wall) and make a mark at the center
of each of the mounting slots with a pencil.
3. Place the unit where it won
’
t get covered with dust when you drill the mounting holes.
4. Using a 6.5mm drill bit,drill a hole through each pencil mark into 35mm deep.
5. Insert the plastic screw anchors into the holes and tap them gently with a
hammer.Tighten the 3*30 screws into the screw anchors,then loosen them two turns.
6. Slide the smoke alarm base up to the screw heads end up in the narrow ends of the
mounting slots, then tighten the screws completely.
7. Insert the 9V battery into the the box, make sure the red pry is under the battery,so the
battery is stable. Diagram 3.
8. Ensure to insert battery
before you install the alarm,
or you will destroy the unit.
9. Close the cover with the
alarm according to Diagram
4,and
then finish your
installation.
TEST
It is important to test this
unit weekly to make sure it is
working properly. Don
’
t open
the alarms by yourself, return them to the seller
if improperly, and don
’
t use fire to test your alarms.
1. Press and hold the test button on the cover of the unit until the alarm sounds. If it does
not alarm, make sure that the unit is receiving power and test it again. If it still does not
alarm, replace it immediately or check your battery.
2. The signal flashes once 30 seconds and while it alarms the signal will flash once 0.5
second.
DIAGRAM 3
9V
batte
ry
9V
batte
ry
+
-
+
-
DIAGRAM 4
PUSH
HOW TO INSTALL THIS SMOKE ALARM
Tools you will need: *Pencil *Drill with 6.5mm drill bit *Standard/Flathead screwdriver