Lewmar CPX 0 ref B10408 iss.2
|
5
1
300 mm
(12”)
4.5 Below deck preparation
IMPORTANT:
The positioning of the windlass must be checked prior to cutting for deck/hull and bulkhead clearance.
⚠ WARNING! Failure to provide minimum
vertical fall will cause jamming.
2
1. The motor/gearbox is bolted via the through deck
mounting bolts.
Do not position motor/gearbox below rode/chain
pipe fall area.
2. There must be sufficient vertical fall for the chain or
rope when hauling in.
4.6 Above deck fitting
Using the template and after you have checked all the
above and below deck requirements cut the following
holes:
Using a 10mm (
3
/
8
”) diameter drill bit, make the three
holes for the mounting studs and two for the motor
cables. With a 76mm (3”) diameter hole saw, make one
hole for the rode to pass through.
±5°
1. Lead from the roller should be fed horizontally back
to the top of the gypsy and along its centre line
within ±5˚
2. Using your template and after you have checked
all the above and below deck requirements cut the
following holes. Using a 10mm (
3/8
”) diameter drill,
make the 4 holes for the mounting studs, 18mm
(
3/4
”) and 14mm (
9
/
16
”) for the sensors. With a 65mm
(2
1/2
”) and 40mm (1
9
/
16
”) diameter hole saw, make 2
holes for the mainshaft and rode to pass through.
3. When all the holes have been made, remove the
template. To help avoid water absorption by the
deck, apply an appropriate marine sealant to the
freshly cut hole edges.
4. Assemble and tighten studs to 21 Nm into base un-
til they bottom out in their holes. Position the flats
of the studs nearest the base of the windlass.
5. Place the base mat in position on the deck. Option-
ally, apply a suitable sealant to the base of the
windlass, any mounting pad or around the studs.
NOTE: If using silicone or other rubbery type seal-
ant, it is advisable to allow curing of the sealant
before final tightening of the mounting nuts.
6. Lightly coat the shaft with grease and ensure the
drive key is in place before assembly to motor/
gearbox.
1
3
4
2
5
6
DO NOT use a permanent
adhesive/sealant eg.5200
