Lewmar AutoAnchor 560 V2, Руководство пользователя

Страница: 11 / 19

3.7.1 Selecting Use Preset
Refer to the Preset Windlass Profile List list in Appendix 1.
Select Use Preset.
Select Windlass profile.
Scroll to the correct Windlass profile for your windlass.
Save and return to Windlass Set up. There are no
further settings.
Exit to Set up menu or hold for 2 seconds to return
to the start screen.
Setting:
This is the length of chain that is released during one complete turn of the chainwheel.
The chain per turn for some windlasses is listed in Appendix 1. If your windlass is not
listed, follow the instructions on page 16 to calculate it.
3.7.2 Chain per Turn for Rope and Chain Rode
Select Chain per turn.
Enter the measurement in mm or metric feet in mm or metric feet
(depending on the units selected). See the
table for metric inch calculations.
Save and return to Rode Set up.
3.7.3 To Enter the Chain per Turn
Setting:
3.7.4 Rope per Turn for Rope and Chain Rode
This is the length of rope that is released during one complete turn of the chainwheel. You
need to measure the length of rope pulled through for 10 turns and divide the result by 10.
See instructions below to calculate the rope per turn.
3.7.5 Calculating the Rope Per Turn
Step 1 Carefully release the chainwheel so that it can be
turned by hand to feed the rode out until you have
rope.
Step 2 As you did for the chain, use adhesive tape to mark
the chainwheel, the deck and the rope. (See the
instructions for the chain per turn above).
Step 3 Using the mark on the chainwheel as a guide, pull the
rope out by hand until the chainwheel has completed
10 turns.
Step 4 Measure the length of rope pulled, divide it by 10.
Step 5 Enter this measurement (See page 18).
Chainwheel Mark
Chain Mark
Deck Mark
Distance to Measure
Select Rope per turn.
Enter the measurement in mm or metric inches in mm or metric inches
(depending on the units selected).
Save and return to Rode Set up. There are no further
settings.
Exit to Windlass Set up. Press twice to exit to the Set Up
menu or hold for 2 seconds to return to the start screen.
3.7.6 To Enter the Rope per Turn
Setting:
3.8.1 Motor driven Sensors
To select the motor driven sensor:
Scroll to Sensor.
Select Sensor.
Scroll to Motor driven reed.
Select.
Scroll to Gearbox ratio.
Select Gearbox ratio.
Increase or decrease the Gearbox ratio.
Save and exit to the Sensor set up menu.
Exit to the Windlass set up menu or hold for
2 seconds to return to start screen.
3.8 SENSOR SET UP
Default setting:
Standard - Applies to all AA sen sors, reed switch
baseplate sensors and proximity sensors. The default setting
should only be changed if you are using a motor driven sensor. (See
below).
Note: The sensor is tuned to the system on first use. See page 21.
3.9 SWAP CONTROLS
Default setting: = Up and = down
Some operators prefer to use the buttons so that
= Out and = In
Access the swap controls feature via the Windlass Set up Menu.
Turn the AutoAnchor Off.
Hold together to access the Set up menu.
Scroll to Windlass.
Select Windlass Select Windlass.
Scroll to Swap Controls.
Select Swap Controls.
Exit to the Windlass Set Up or hold for 2 seconds
to return to start screen.
Note: This feature can not be used to correct wiring errors.
17
18