Lewmar 140TT Скачать руководство пользователя страница 3

4

Electric/Hydraulic Stern Thruster

Models 185TT, 250TT & 300TT

GB

5

Electric/Hydraulic Stern Thruster

Models 185TT, 250TT & 300TT

GB

Introduction

Important information 

about this manual

Throughout  this  manual,  you  will  see  safety  and 

product  damage  warnings.  You  must  follow  these 

warnings  carefully  to  avoid  possible  injur y  or 

damage.
The  type  of  warnings,  what  they  look  like,  and 

how they are used in this manual are explained as 

follows:

 

  Warning!

 

This  is  a  warning  against  anything  which  may 

cause injury to people if the warning is ignored. 

You are informed about what you must or must not 

do in order to reduce the risk of injury to yourself 

and others.

  Safety Symbol

 

When you see the safety symbol it means: “Do 

not...”;  “Do  not  do  this”;  or  “Do  not  let  this 

happen”.

Dear Customer,
Thank  you  for  chosing  Lewmar  TT  Thrusters. 

Lewmar  products  are  world  renowned  for  their 

quality, technical innovation and proven performance. 

With a Lewmar winch you will be provided with many 

years  of  outstanding  service.  We  wish  you  happy 

sailing.

Product support

Lewmar  products  are  supported  by  a  worldwide 

network  of  distributors  and  Authorised  Service 

Representatives.  If  you  encounter  any  difficulties 

with  this  product,  please  contact  your  national 

distributor, or your local Lewmar dealer. Details are 

avaiable at:

To the best of our knowledge, the information in 

this manual was correct when it went to press. 

However,  Lewmar  cannot  accept  liability  for 

any inaccuracies or omissions it may contain. 

In addition, our policy of continuous product 

improvement  may  change  specifications 

without  notice.  As  a  result,  Lewmar  cannot 

accept liability for any differences between the 

product and the manual.

www.lewmar.com

 Approvals

For CE approval certificates contact Lewmar.

General

Please ensure that you thoroughly understand the 

operation  and  safety  requirements  of  the  thruster 

before  commencing  the  installation.  Only  persons 

who are completely familiar with the controls and 

those who have been fully made aware of the correct 

use  of  the  thruster  should  be  allowed  to  use  it.  If 

there is any doubt of how to install or operate this 

unit  please  seek  advice  from  a  suitably  qualified 

engineer.

•  Please ensure that you thoroughly understand 

the  operation  and  safety  requirements  of  the 

thruster.

•  Your thruster should not be operated close to 

swimmers,  as  a  powerful  suction  of  water  is 

generated when in use.

•  The tunnel installation and any hull modifications 

should only be carried out by a specialist. This 

manual is based on a GRP tunnel installation.

•  We recommend that a qualified person install 

the  thruster.  Faulty  installation  will  place  the 

boat and crew in danger and make the warranty 

invalid.

•  Sailing, like many other sports can be hazardous.  

Even  the  correct  selection,  maintenance  and 

use of proper equipment cannot eliminate the 

potential for danger, serious injury or death.

•  It is the unavoidable responsibility of the owner 

or master or other responsible party to assess 

the risk of any operation on the vessel.

•  Lewmar  recommends  the  use  of  appropriate 

Personal  Protective  Equipment  and  hands 

free communication equipment by any person 

going  aloft,  and  only  then  where  the  person 

going aloft is properly trained in the use of that 

equipment  and  where  there  remain  sufficient 

trained and experienced personnel on deck to 

ensure constant observation and the continued 

safe conduct both of the vessel and the hoisting 

operation.

Safety notices

Fitting

•  This equipment must be installed and operated 

in accordance with the instructions contained in 

this manual. Failure to do so could result in poor 

product  performance,  personal  injury  and/or 

damage to your boat.

•  Electric  bow  thrusters  use  powerful  electric 

motors,  it  is  ver y  important  that  there  is 

sufficient  battery  capacity  and  large  enough 

cables  for  safe  operation.  Using  smaller  than 

recommended  battery  and  cables  will  cause 

loss of performance and may cause dangerous 

overheating.

•  Electric motors spark and run hot. Do not place 

near flammable or sealed areas.

•  Main battery must not be connected and power 

must  not  be  switched  on  until  all  covers  and 

terminal protectors are correctly fitted.

•  It is very dangerous to run the thruster out of 

the  water,  even  for  a  few  seconds,  the  motor 

will over speed by 300%, causing damage to the 

seals etc. and the propeller will cause serious 

damage to whatever comes into contact with it 

and invalidate the warranty.

•  Consult the boat manufacturer if you have any 

doubt  about  the  strength  or  suitability  of  the 

mounting location.

Electrical

•  Make  sure  you  have  switched  off  the  power 

before you start installing this product.

•  If in doubt about installing electrical equipment 

please  seek  advice  from  a  suitably  qualified 

electrical engineer.

  This  manual  forms  part  of  the  product 

and  MUST  BE  RETAINED  along  with,  OR 

incorporated into, the Owner’s Manual for 

the vessel to which the windlass is fitted.

Содержание 140TT










Отзывы: