Page 6
Assigning dimmer channels to each scene.
Each of the scenes of the 404CP and 408CP must be programmed with the desired dimmer
channel assignments.
Only the dimmer channels assigned will be affected by each scene button.
In order to easily identify dimmer channels while programming, the system should have all
installed lamps or loads operational. If this is not possible, the panel to be programmed should
be temporarily connected nearby to the dimmer units so that the control LEDs of the dimmers
may be observed to verify channel selection.
To program each scene:
1.
Make sure that the 404CP or 408CP is in the program select mode as discussed. The
BUSY LED should be flashing.
2.
Press the SCENE 2 button to select “dimmer assignment mode” and the BUSY LED will
stop flashing.
3.
Press button representing desired scene to be programmed. At this point, all currently
assigned dimmers will come on. The current dimmer selector will be set to one.
4.
Use the buttons marked as UP and DOWN in diagram to increment or decrement the
dimmer channel selector.
Tap the buttons the required number of times to reach the dimmer channel to be assigned.
5.
Use the ADD and DELETE buttons to add or delete this dimmer from the zone. The lamps
connected to this dimmer channel will come on full when the ADD button is pressed.
Observe lamps or dimmer LEDs to verify correct channel has been selected.
6.
Next, exit this programming mode; press both the UP and DOWN buttons at the same time.
The BUSY LED will start flashing again when both buttons are released.
7.
A new scene can be programmed at any time by repeating the above procedure.
SCENE 1 SCENE 2 SCENE 3 SCENE 4
DIMMER ASSIGNMENT MODE
SCENE 1 SCENE 2 SCENE 3 SCENE 4
SCENE 5 SCENE 6 SCENE 7 SCENE 8
LUMA-NET
LUMA-NET
404 CP
408 CP
DOWN
UP
ADD
DELETE
DOWN
UP
ADD
DELETE
PWR
BUSY
PWR
BUSY
WEB
VERSION
