BOM (Broadcasting Outer Module) Company Standards
Effective Date
12/6/17
Page
6
of
12
Document No.
42
Revision
1
Code Number
D-0005
3.2
Design Requirement
All systems of the BOM must meet all the design parameters as set by the different system’s
operational requirements and/or drawing specifications. Engineering drawings must include
the information necessary to duplicate each product to comply with this standard.
4.
Flammability Testing Requirements
The material of the BOM, produced under this design standard, must comply with the
requirements of Civil Aeronautics Regulation 3, definition of flame resistance, when tested as
a complete assembly.
5.
Structural Strength Requirement
The structure must be able to sustain 6G pull test in the vertical axis when installed in test
fixture representative of an aircraft panel. The 6G requirement is based on the mass of the unit
for which the part is intended to accommodate.
6.
Software Validation
Software/Hardware integration shall be designed and tested using ASTM F3153-15 practices
and reports.
7.
Electronic Emissions
Wi-Fi equipment has been tested and found to comply with the limits for a Class digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to the radio communications. However, there are
no guarantees that interference will not occur in a particular installation. The Wi-Fi transceiver
must have a MAX of 10 mW output power.
8.
ADS-B IN
Unit meets the performance requirements for the FAA TSO-C154C for sections appropriate
for ADS-B In operation. This will include:
RTCA DO-282B (Section 2.2.8, 2.2.9 and 2.2.10) for 978 MHz receiver.
