Attaching the casters
Attach the casters (j and k) to the underside of the
base (E) using 4 caster screws (g) for each caster.
We recommend attaching the locking casters (j)
at opposite corners to keep the table in place.
2
Attaching the handles
Attach the magazine rack support (F) to the
rack base (G) by inserting 2 thick dowels
(d) into the outer holes on the base. Set the
support over the dowels and attach to the
base using 2 large screws (h).
Attach the handles by setting the curved
handles (m) over the predrilled holes in the
support and base. Insert 8 handle screws (f)
through the handles into the rack.
3
Building the body
Insert thick wood dowels into the holes on both
ends of the stretcher (B), the holes on the top of
the back (A) and the middle holes on the sides (C
and D).
Insert bolts (c) through a split washer (b) and a
regular washer (a). These are referred to as bolt
assemblies.
Set the stretcher on top of the back. Press the
right side (C) so the dowels fit into the
corresponding holes on the back. Insert 3 bolt
assemblies through the inside for the back rails
into the sides. Be sure to fully tighten the bolts to
avoid damage or injury. Repeat for the left side.
4
Attaching the base
Insert thick wood dowels into the outer holes
on the bottom of the sides and back. Set the
base over the dowels. Attach the base to the
assembly using 6 long screws (h).
Set the metal cross bar (o) over the holes at the
end of the base. Insert 2 small bolts (i) through
the underside of the base into the cross bar.
5
