Chapter 6 Network parameters
http://www.level1.com
Page 28
3. PPPoE access
Figure 6-7 List of line connection information - PPPoE access
If a line is a PPPoE dialup one, then click on the interface, the "Dial-up" and "Hang-up" will
appear below the "Line connection information list", as shown in the figure above, the
WAN1 port is PPPoE access, click on "WAN1", and four buttons are displayed on the
lower right part of the line connection information list.
Connection status: As being in "Connected", the time that the line remains the
connection will be displayed.
IP address, subnet mask, gateway address: IP address, subnet mask, and gateway
address assigned by the connected device to the interface.
Delete: Deletes the appropriate line.
Dial-up: Click <Dial>, to establish the PPPoE access, 3G access line unestablished
or disconnected (When the PPPoE connection dial-up type is set to "Manual dial-up",
and the PPPoE dial-up is to be completed here).
Hang up: Click <Hang-up>, to hang up the PPPoE dial-up line or 3G access line that
has been established.
Refresh: Click <Refresh>, to display the up-to-date information of line connection
information list.
6.2
Line combination
This section describes the
Network parameter -> Line combination
page.
In the line combination configuration, you can quickly configure line combination modes,
and other related parameters, and specify the detection interval, detection number,
detection target IP address and bandwidth of the lines.
