62
3-4. Loop Detection
Looping will always occur when the switches are connected as a cycle and a switch
transmits the packets that will go back to the transmitted switch. Loop Detection will
prevent the looping from happening. Moreover, it could remove the looping
phenomenon per port. In general, you can unplug the cable connection to stop the
looping when a port causes the looping. The switch has powerful Looping Detection
capability, which could cease the looping immediately.
Function name:
Loop Detection
Function description:
This function will start when you enable looping action by ticking the
check box (
;
) of the Action. That will create some special packet for
looping detection. After enabling looping action, you should decide which
port you would like to open loop detection capability. For example, you
open the loop detection of port 1 as enable state. When the looping
situation happens from port 1, Loop Detection will lock the port1’s ability.
And then you will see that the “Current Status” of port 1 shows Locked. In
port status function, you can see that the State of Port Configuration of
port 1 is “Disabled”. So the port 1 will lose the essential ability the port
could have. However, “Resume Action” in Loop Detection will remove the
looping status. It is very convenient for looping happening in real
Содержание ProCon GSW-2693
Страница 8: ......
Страница 34: ...26 Fig 2 14 Daisy Chain Fiber Network Connection Fig 2 15 Uninterrupted Power Supply for IP Phone Application...
Страница 81: ...73 Fig 3 21...
Страница 88: ...80 3 8 5 Management Vlan...
