IES-1610
Page 4
Power Input
Terminal Bl
ock
Power1
+
12 – 48VDC
–
Power Ground
Power2
+
12 – 48VDC
–
Power Ground
Earth Ground
Relay Output
1.
The relay contact closes if Power1 or Power2 falls
2.
The relay contact closes if Power3 is failed but both Power1 and Power2 are On
Power3: 12VDC DC Jack Input type
IES-1610
Page 5
DIN Rail Mount
•
Assembly: Place the switch on the DIN rail from above using the
slot. Push the front of the switch toward the mounting surface
until it audibly snaps into place
•
Start-up: Connect the supply voltage to start up the switch via
the terminal block (or DC JACK)
•
Dismantling: Pull out the lower edge and then remove the switch
from the DIN rail.
IES-1610
Page 6
10/100Base-TX Connector
The following lists the pin-out of 10/100Base-TX ports.
Pin
Standard Port
Uplink Port
1
Output Transmit Data +
Input Receive Data +
2
Output Transmit Data -
Input Receive Data -
3
Input Receive Data +
Output Transmit Data +
4
NC
NC
5
NC
NC
6
Input Receive Data -
Output Transmit Data -
7
NC
NC
8
NC
NC
IES-1610
Page 7
100Base-FX Connection
The Tx (transmit) port of device I is
connected to the Rx (receive) port
of device II, and the Rx (receive)
port of device I to the Tx (transmit)
port of device II.
WDM 100Base-BX Connection
Only one optical fiber is required to
transmit and receive data
