IDENTIFYING EXTERNAL COMPONENTS
This chapter describes the front panel, rear panel, and LED indicators
of the Switch.
Front Panel
The figure below shows the front panels of GSW-2475T.
Figure 4. Front panel of 24-port Gigabit Ethernet Switch
LED Indicator:
Comprehensive LED indicators display the status of GSW-2475T and
the network (see the LED Indicators chapter below).
Gigabit Ethernet Ports (Port 1~24):
The Switch sixteen Gigabit twisted pair ports, supported auto negotiable
10/100/1000Mbps and auto MDI/MDIX crossover detection function, this
function gives true “plug and play” capability, just need to plug-in the
network cable to the hub directly and don’t care if the end node is NIC
(Network Interface Card) or switch and hub.
These ports can operate in
half-duplex mode for 10/100Mbps and full- duplex mode for
10/100/1000Mbps.
mini-GBIC Ports
GSW-2475T is equipped with two mini-GBIC ports, supported
optional 1000BASE-SX/LX mini-GBIC module.
Port 23 and 24 are the same ports with the mini-GBIC no.23 and 24
ports, when plug in the mini-GBIC module, the device will activate
mini-GBIC, and the RJ45 port will be disabled.
Note: When the port was set to “Forced Mode”, the Auto
MDI/MDIX will be disabled.
13
