- 3 -
2. Installed on the working table
Install the switch on a working table, and the installation steps are as follows:
l
Place the switch with its bottom up on a sufficiently large, stable and properly-grounded working table;
l
Flip over the switch, and place it on the working tablestably;
l
Use a power cord to connect the switch power connector with the power socket.
l
The switch uses 100-240V, 50/60Hz AC, and make sure that both power supply and grounding are
normal before power on.
l
After power on, please check the switch's power indicator (Power) is on, and if so, it indicates that
the power supply is connected properly.
l
Do not place heavy objects on the top of the switch.
Perform Initial Configuration
l
Connect PC to the switch console port using console cable.
l
Configure the PC’s serial port:
115200
bps, 8 characters, no parity, one stop bit, 8 data bits, and no
flow control.
l
Log in to the CLI using default settings: Username “admin” and password “admin.”
Note:
For further information on switch configuration, refer to the CLI Reference Guide and Web
Management Guide.
Logging on to the equipment
l
Connect the RJ-45 interface cable of a switch with a computer using a network cable.
l
Set the TCP/IP properties of the computer, see the
Appendix: Setting up yourcomputer
.
l
Logging on to the equipment: Open a browser and type
192.168.1.1
in the address bar, and then
press Enter; in the pop-up login interface, enter the factory logon
username
"
admin
",
password
"
admin
" and click OK.
