-4-
4.
Installation
A.
Installing Media Converter Rack to a Wiring Closet Rack
⇒
Install four screws through mounting ears into each side
⇒
Locate Converter Rack at 19-inch mounting rails and screw up the front brackets
⇒
Set Main power switch at "OFF" position before connecting the power cord
B.
Installing Media Converter to a Media Converter Rack
⇒
The slide-in Media Converters and Converter Rack should be supplied only from the same source,
both Media Converters and Rack are built to match each other at dimensions, DC power jack, DC
receptacle and power safety.
⇒
Turn off the 19" converter rack power
⇒
Verify the Media Converter is right for this Rack and 5VDC power jack on converter back,
carefully slide in and plug to match 19" rack slot +5V DC receptacle
⇒
Ensure that there is no activity in the network
⇒
Connect the media cable for network connection
⇒
Turn on the converter rack power, the Power LED will light up
Fiber Port: Attach the fiber cable. The Tx, Rx fiber
cable must be paired at both ends
TP Port: Attach UTP Cat. 3 or 5 cable to TP port
MPR : To a Hub or Repeater
DTE : To a workstation or NIC
Slide switch "DTE" / "MPR" is on the
side panel. Default: MPR
BNC Port: Attach T -Connector to BNC port and
connect the RG-58 coaxial network.
Ensure the coaxial cable/segment is
terminated at both ends properly
Note:
1.
Use the
straight-through cable. Cable pin-outs for RJ-45 jack are 1, 2, 3, 6 to 1, 2, 3, 6
2.
MPR(Default):
To a Hub or Repeater
DTE
:
To a workstation or
NIC(Network Interface Card)
(DTE pin -outs are crossover on board ready)
3.
Configure the MPR-DTE slide switch on the side panel for cable connection to a hub or
NIC(Network Interface Card)
2.5mm
DC Receptacle 2.5mm
1A@+5V for each slot
Each slot of 19-inch Converter
Rack, its DC receptacle is 2.5mm
wide that conforms to the Media
Converter 2.5mm DC jack's
central post.