8
PARENT UNIT OPERATION
This system is capable of running on batteries or by AC adapter.
Battery Powered
1.
Remove the battery compartment cover on the back of the parent unit using a small
screwdriver.
2.
Slide cover down and off using your thumb.
3.
Install 3 AAA batteries.
4.
Replace battery compartment cover.
Adapter Powered
1.
Plug the small end of the AC adapter into the 6V DC jack on the right hand side of
the parent unit.
2.
Plug the other end of the AC adapter into any available wall outlet.
Turning On and Volume Control
The ON/OFF control and volume control utilize the same thumbwheel on the parent unit.
1.
Turn the thumbwheel on the top of the parent unit to the left, you will hear a click
and the parent unit will now be on.
2.
A green LED on the front of the parent unit will indicate there is power.
3.
Continue to turn the wheel to the left to increase the volume of the parent unit. Turn
back to decrease the volume.
4.
To Turn OFF the parent unit, turn the wheel to the right until you hear a click again,
the LED indicator will go out.
Channel Selection
This system has two channels to operate on in case there is another product in the household
using the same frequency.
1.
To change the channel the system is using, slide the channel selection switch on the
left hand side of the parent unit to either CH1 or CH2.
2.
Both the parent and baby units must be on the same channel to operate and transmit
properly.
Note:
3 AAA batteries are required for both the parent and child units, batteries are
not included.
