Safety
TNT
35/7-2
4
V
Review state, , Monday, 19. January 2009
2
Safety
Before using the Safety Locking Device, a risk evaluation must be performed
according to valid standards (e.g. EN ISO 12100-1, EN ISO 13849-1,
EN ISO 14121). For mounting, operating and testing, document "Safe implemen-
tation and operation of the L10" as well as all applicable national and international
standards, regulations, rules and directives must be observed (e.g. machinery
directive, low-voltage directive, work-equipment directive, safety regulations,
accident-prevention regulations, EN 1088, EN ISO 13849-1, EN 60204-1,
EN 954-1). Observe and print out relevant and supplied documents and distribute
to the affected personnel.
ª
Before beginning work with the Safety Locking Device, completely read and
understand the documents applicable to the respective task.
The following standards apply for the risk evaluation at the protective device prior
to using the Safety Locking Device:
• EN ISO 14121, Safety of machinery, risk evaluation
• EN ISO 12100-1, Safety of machinery
• EN ISO 13849-1, Safety-related parts of control systems
The realizable category of the integration in control circuits according to
EN ISO 13849-1 and EN 954-1 is dependent on the used contact block and
wiring.
In particular, the following national and international legal regulations apply for the
start-up, technical inspections and work with Safety Locking Devices:
• Machinery directive 2006/42/EC
• Low voltage directive 2006/95/EC
• Use of work equipment directive 89/655 EEC
• Safety regulations
• Accident-prevention regulations and safety rules
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: [email protected]
