Leuze electronic PRK3CLA Autokollimation, Руководство пользователя

Страница: 7 / 10

IO-Link interface
Sensors in the PRK3C…/L… variant have a dual-channel architecture. The IO-
Link interface is available in accordance with specification 1.1.2 (July 2013) on pin
4 (OUT 1). You can easily, quickly and economically configure the devices via the
IO-Link interface. Furthermore, the sensor transmits the process data via the IO-
Link interface and makes diagnostic information available through it.
Parallel to the IO-Link communication, the sensor can output the continuous
switching signal for object detection on OUT 2. The IO-Link communication does
not interrupt this signal.
NOTICE
In the Sensor Studio configuration software, the following applies with
regard to the designations: Q1 = OUT 1, Q2 = OUT 2.
The sensors offer no data retention and no ISDU support. The device can only be
identified via VendorID and DeviceID.
IO-Link identification
VendorID dec/hex DeviceID dec/hex Device
338/0x152 2119/0x000847 PRK3CL1.A3/LP
IO-Link process data
Device output data
Data bit Assignment Meaning
0 Switching output Q1
(OUT 1) 0 = inactive, 1 = active
1 Warning output autoCon-
trol 0 = no warning, 1 = warning
2 Sensor operation 0 = off, 1 = on
Sensor operation off when detection is
not possible (e.g during the teach event).
3 Not assigned Free
4 Not assigned Free
5 Not assigned Free
6 Not assigned Free
7 Not assigned Free
7
EN