ODSL 96B M/… - 05
2013/01
Teach-in of switching outputs, analog characteristic output curve and Preset
Notice!
If you have changed the factory setting for teaching under Input Mode, activate on the OLED display the menu item
Input
->
Input Mode
->
Teach
.
To teach, proceed as follows:
1.
Position measurement object at the desired measurement distance.
2.
The respective teach function is activated on the teach input for the duration of a level change
T
(see graphical representation).
The level conditions describe the levels with menu setting
Input
->
Input Mode
->
Input polarity
->
Active High +24V
(factory
setting).
Notice!
If the inactive level is continuously applied on the teach input, the teach input is locked.
For menu setting
Input
->
Input Mode
->
Input polarity
->
Active Low +0V
, inverted input signals are used during
teaching.
Preset Teach-In
On the OLED display, activate for this purpose menu item
Input
->
Input Mode
->
Preset
.
The preset teach occurs in a manner analogous to that for the teach-in for switching output Q1.
Working safely
Attention Laser Radiation!
The optical distance sensors ODSL 96B operate with a red light laser of class 2 acc. to EN 60825-1. If you look
into the beam path over a longer time period, the retina of your eye may be damaged!
Never look directly into the beam path! Do not point the laser beam of the ODSL 96B at persons!
When mounting and aligning the ODSL 96B take care to avoid reflections of the laser beam off reflective
surfaces!
The use of operating and adjusting devices other than those specified in the technical description, carrying out
of differing procedures, or improper use of the optical laser distance sensor may lead to dangerous exposure to
radiation!
The use of optical instruments or devices in combination with the device increases the danger of eye damage!
Adhere to the applicable legal and local regulations regarding protection from laser beams acc. to EN 60825-1 in
its latest version.
The ODSL 96B uses a laser diode with low power in the visible red light range with an emitted wavelength of
about 658nm.
The glass optics cover is the only opening through which the laser radiation can escape from the device. The
housing of the ODSL 96B is sealed and has no parts that need to be adjusted or maintained by the user. The
device must not be tampered with and must not be changed in any way! The destruction of the seal voids the
warranty!
Notice!
It is important that you attach the sticky labels supplied to the device (notice signs and laser emission symbol)!
If the signs would be covered due to the installation situation of the ODSL 96B, attach them close to the
ODSL 96B such that reading the notices cannot lead to looking into the laser beam!
Teach function
Duration T
Switching output Q1
20 … 80ms
Distance value for start of measurement range =
1V or 4mA at analog output
220 … 280ms
Distance value for end of measurement range =
10V or 20mA at analog output
320 … 380ms
Inactive Low 0V
T
t
Active High +24V
ODSL 96B