Page 4 of 9
STEP 7:
STEP 6:
Install one Wing
[P]
onto
each side of the Stem.
Secure with Ring Pin
[N]
.
[Fg. 13 & 14]
NOTE:
The Ring Pin
[N]
MUST
always be inserted
through the hole on the
Stem
[H]
from above/
inside the Stem upright
as shown.
NOTE:
You can use a
straight tool (such as a
Lower Wheel Cradle
[R]
)
to tighten the Ring Pins
further if needed.
H
N
P
H
P
[Fg. 13]
[Fg. 14]
TIP!:
The BikeWing carrier and mounted bicycles can be locked to the vehicle using a standard cable lock (not
included) by running a cable through the Ring Pins
[N]
, the hehicle hitch and the mounted bicycles.
Using one (1) Wing
[P]
, slide both foam
bumpers to the center of the Wing.
Turn the handles on each Cradle Housing
O]
to loosen their grip.
Slide two (2) Cradle Housings
[O]
above the
foam bumpers and two (2) more Cradle
Housings below the foam bumpers. [Fg. 10,
11 & 12]
NOTE:
The cylinders located on each Cradle
Housing
[O]
MUST
rest along the
same sides as the connection hole located at
the bottom of the Wing
[P]
.
NOTE:
It is recommended to Position the
cylinders located on each Cradle Housing
[O]
so that they alternate direction as shown.
Re-tighten each Cradle Housing
[O]
handle to
secure in place on the Wing
[P]
.
Repeat this step for the second Wing
[P]
.
CYLINDER
CONNECTION
HOLE
FOAM
BUMPERS
O
P
P
P
O
O
O
[Fg. 10]
[Fg. 11]
[Fg. 12]
