Letos YC0004, Руководство пользователя

Страница: 5 / 6

6
7
Unfolding method
：
4.Operation & Maintenance
1
）
Take off the cover.
2
)
According to the direction
and size of the roof rack,
loosen the screws and adjust
the direction and distance of
the two connecting-tubes,
tighten the screws, then carry
the tent onto the car roof.
3
）
Adjust the tent to appropriate
position on the car roof. (Make
sure the trunk door can be
opened.)
5
）
The bolts pass through the hole of the U-shaped fixing plate, flat
washer then spring washer in proper order, then tighten the M8
self-locking nut using a ratchet wrench.
Please be noted total 4 pcs U-shaped fixing plates shall be fixed on 4
corners respectively.
M8 Flat gasket
M8 Spring washer
M8 self-locking
nut
1
)
Please check the car if there
are original rack on its roof and
the distance between the rack
and the car roof is bigger than
3cm,otherwise , you need to
get a set of suitable roof rack
and install it first.
4
）
Slide the M8 x 50 bolts to
appropriate position from the
end of the connecting tube,
2pcs at each end.
Please be noted , when the
distance between roof rack
and car roof is less than 4cm ,
the short bolts M8x30 will be
used instead of the long bolts
M8x50.
6
）
Insert the plastic cap (30x30cm)
into the end of the connecting
tubes.
Insert the latch into the hole of the U-shaped connecting piece on both sides after the tent is
unfolded fully.
Adjust the length of the bandage and then hook on the wheel of the car.
Press the top tube of the telescopic ladder into the retainers at the front of the bedframee, Then
fasten the bandage together with the bedframe.
Hold the two bandages in the front of the tent, pull forward to unfold the tent.
Make sure nothing inside before folding, pull out the latches from the holes of the U-shaped
connecting piece ,then remove the bandage hook from wheel , hold the bandages and gently
loosen until the tent is folded fully.
Loosen the bandage, take off the ladder from the retainer .Step on the lowest crosspiece with
one foot, grasp the ladder with one hand, and press the left and right switches of the lowest
crosspiece to collapse the ladder.Place the collapsed ladder into trunk.
Cover the water proof cover after folded , hook it around the bedframe.
Adjust the ladder to a suitable height. When in use the ladder must be at an angle of 75 degrees
between the floor and ladder.
3)
2)
4)
5)
6)
7)
8)
9)
Ratchet
wrench
3.Installation steps
Folding method
：