Lester 18710 T, Руководство по эксплуатации

Страница: 1 / 7

www.lesterelectrical.com 1 01610K
LESTRONIC II 48 VOLT AUTOMATIC
BATTERY CHARGER
MODEL 18710 TYPE 48LC25-8ET
Specifications
AC Input: 120 volts, 15 amps, 60 Hertz, single-phase
DC Output: 48 Volts, 25 Amps, Tapering to 8 Amps
Battery Specifications: For use with 48-volt, 24-cell, series connected, 180-350 amp-hour, liquid electrolyte
(wet) lead-acid batteries
PLEASE SAVE THESE IMPORTANT SAFETY AND OPERATING INSTRUCTIONS
For correct operation of the equipment, it is important to read and be familiar
with this entire manual before installing and operating the charger.
DO NOT DISCARD THIS MANUAL AFTER READING.
LOOK FOR THIS SYMBOL TO POINT OUT SAFETY PRECAUTIONS. IT MEANS:
BECOME ALERT—YOUR SAFETY IS INVOLVED. IF YOU DO NOT FOLLOW THESE
SAFETY INSTRUCTIONS, INJURY OR PROPERTY DAMAGE CAN OCCUR.
IMPORTANT SAFETY INSTRUCTIONS
This manual contains important safety and operating
instructions. Before using battery charger, read all
instructions and cautionary markings on battery
charger, battery, and product using battery.
•
Do not expose charger to rain or snow.
•
Use of an attachment not recommended or sold by
the battery charger manufacturer may result in a
risk of fire, electric shock, or injury to persons.
•
To reduce risk to damage to electrical plug and
cord, pull by plug rather than cord when
disconnecting charger.
•
Make sure cord is located so that it will not be
stepped on, tripped over, or otherwise subjected to
damage or stress.
•
When using an extension cord, make sure that:
°
Pins on plug of extension cord are the same
number, size, and shape as those of plug on
charger;
°
Extension cord is properly wired and in good
electrical condition;
°
Wire size is large enough for AC ampere rating
of charger.
•
Do not operate charge with damaged cord or plug;
replace it immediately.
•
Do not operate charger if it has received a sharp
blow, been dropped, or otherwise damaged in any
way. Take it to a qualified service center.
•
Do not disassemble charger; take it to a qualified
service center when service or repair is required.
Incorrect reassembly may result in a risk of electric
shock or fire.
*01610*