Section 3 - Sofas without Arms
1. Follow instructions in Section 1 to attach
each seat to each back. Cushions inside
each carton belong together.
Do not
intermix.
Align edges and tighten bolts
securely.
2. Orient chairs side-by-side, as shown in figures 5
and 6. Pay close attention to correct leg positions.
Note that center chairs have bolt holes on both
sides. End chairs have bolt holes on one side only.
3. Connect adjoining chairs using bolts, washers and
nuts. Use 2” bolts between seats and 3” bolts
between backs. Finger tighten only.
Hint: start
with bolt in back cushion first, followed by front
seat bolt, then middle bolt last.
4. Place chair assembly upright on a level surface and
align bottom edges of adjoining seats and backs.
5. Tighten all bolts securely.
6. Your product is now assembled and ready to use.
© 2014 Lesro Industries, Inc.
Section 4 - Sofas with End Arms
Figure 7
Section 5 - Connecting Chairs with Center Arms
1. Follow instructions in Section 1 to attach
seats to backs. Align edges and tighten
bolts securely.
2. Identify left, right, and center arm pieces. Center
arms have bolt holes on both sides. Left and right
arms have bolt holes on one side only.
3. Orient chairs and arms side-by-side, as shown in
figures 9 and 10.
4. Attach arms to seats and backs using 2” bolts and
washers into threaded inserts. Start each bolt first,
until all have caught a few threads, then finger
tighten only.
Hint: start with bolt in back cushion
first, followed by front seat bolt, then middle bolt.
5. Place chair assembly upright on a level surface and
align bottom edges of adjoining seats, backs, and
arms. Tighten all bolts securely.
6. Your product is now assembled and ready to use.
Align
edges
when
tightening
bolts
1. Follow instructions in Section 3 to
attach each seat to each back and to
connect adjoining sections. Pay close
attention to correct leg positions, as
shown in figure 7. Align edges and tighten
bolts securely.
2. Attach arms to seats and backs using 2” bolts
and washers into threaded inserts, as shown
in figure 8. Start each bolt first, until all have
caught a few threads, then finger tighten only.
Hint: start with bolt in back cushion first,
followed by front seat bolt, then middle
bolt last.
3. Place chair assembly upright on a level
surface and align bottom edges of adjoining
seats, backs, and arms. Tighten all bolts
securely.
4. Your product is now assembled and ready
to use.
Figure 5
Figure 6
Figure 8
Figure 9
Align
edges
when
tightening
bolts
Align
edges
when
tightening
bolts
Figure 10
See www.lesro.com for an enlarged view of this figure
See www.lesro.com for an enlarged view of this figure
