Lesco Elite Zero Pump, Инструкция по использованию и уходу

Страница: 10 / 48

SPRAYER MAINTENANCE CONTINUED
Page 10
6. Reach into the Tank and carefully grasp the cylindrical Filter located at the bottom of the Tank.
7. Turn the filter approximately 1/8 of a turn counter-clockwise until it stops turning.
8. Pull up on the Filter and remove it from the Tank.
9. The Filter can be cleaned by carefully rinsing from the inside to the outside. Be sure not to tear or
damage the mesh. Any damage to the mesh may allow debris to enter the pump and cause clogging or
damage to the pump.
10. If the Filter is damaged or too dirty to permit cleaning, it must be replaced with a new Filter.
11. To re-install the Filter gently set it back over the Filter Base in the bottom of the Tank, and slowly turn
the Filter until the locking tabs on the Filter Base align with the grooves in the Filter. The Filter will
drop downward approximately 1/8 inch when this happens.
12. Push down on the Filter until it stops, approximately another 1/4 inch, then turn the Filter
approxmately 1/8 turn clockwise until it stops.
Harness Installation
1. For each side, remove the small plastic Clips
from the two Shoulder Strap loops and thread
each loop through the slots at the top of the
Carry Handle. Replace the Clips through the
loops and pull Strap securing the two Shoulder
Straps in place. (See Figure 1)
2. To install lower end of the Straps, remove Strap
from top portion of Buckles and place around
the Foot Stand, starting from underneath.
(See Figure 2)
3. Loop Strap through the first section of Buckle.
(See Figure 3)
4. Next loop Strap through other section of
Buckle and tighten
(See Figure 4)
. Adjust the
Shoulder Pads and Strap length for a
comfortable fit.
Figure 4 Figure 3
Figure 2 Figure 1
Filter Installation and Removal Process
Figure 1 Figure 2
Figure 1: Align notches on Filter with tabs on Base.
Figure 2: Rotate Filter 1/8 turn to lock/unlock.