Shenzhen LEPU Intelligent Medical Equipment Co., Ltd.
Form No.: LP-QR-RD-016 REV.01
Page 3of 7
1.9 Sound switch settings
In shutdown mode, press and hold the button "MEM”, it first displays “---- M”, which flashes
along with the symbol "M"; press and hold the memory button for more than 4 seconds, it displays
“---- C + human icon + sound icon"; if the sound is on currently, a “bi” will be heard when
entering this mode.
Release the button at this time, it enters the sound setting mode; press the button "MEM” to
change the sound once; a “bi” will be heard and the sound icon goes out when the sound is
enabled; press the button again to change the sound, the sound icon comes on and there is no “bi”
heard as the sound is disabled.
Note:
The equipment will shut down automatically if there is no button press for 60 seconds. It defaults
to the current setting after rebooting, while it will save previous settings in case of power failure.
1.10 Body temperature measurement
Toggle the slide switch to the body mode, press the button "ON/OFF measurement” to turn
on the forehead thermometer, align the thermometer sensor to the position between eyebrows
within 5cm from the forehead, press the button "ON/OFF measurement”, at this time, the distance
focusing light comes on, quickly adjust the appropriate distance (preferably when the focusing
light spot is within the pea grain size), when a "bi" is heard about 1S later (no “bi” heard if the
sound is disabled), it means that the body temperature has been measured, with the result
displayed on the LCD screen;
Note:
When the measured temperature is below 37.4
℃
, the LCD backlight is green.
When the measured temperature is between 37.5
℃
-38.5
℃
, the LCD backlight is yellow,
reminding of low fever.
When the measured temperature is higher than 38.6
℃
, the LCD backlight is red, reminding
of high fever with sound of “Bi", "Bi", "Bi”.
1.11 Object temperature measurement
Toggle the slide switch to the calibration mode, press the button "ON/OFF measurement” to
turn on the thermometer, align the thermometer sensor to the object to be measured, press the
button "ON/OFF measurement”, at this time, the distance focusing light comes on, quickly adjust
the appropriate distance (preferably when the focusing light spot is within the pea grain size),
