10
Step 2
Push down the metal clasp and pull the transceiver out by the plastic part as shown
below in Figure 2.11
Figure 2.11: Pull Out from the SFP Module
Wiring the Power Inputs
Caution:
Please follow the below steps to insert the power wire.
Step 1
Insert the positive and negative wires into the PWR1 (V1+, V1-) and PWR2 (V2+, V2-)
contacts on the terminal block connector as shown below in Figure 2.12.
Figure 2.12: Power Terminal Block
Step 2
Tighten the wire-clamp screws to prevent the wires from loosening, as shown below in
Figure 2.4.
Figure 2.4: Power Terminal Block