Bulletin G10-E
January 2006
INSTALLATION ADJUSTMENT SERVICE
HIGH-LOW MANIFOLD
TM-2020A
ASSE 1017 LISTED
IMPORTANT! Provide serial numbers for both valves when ordering parts!!
INSTALLATION
1360 Elmwood Avenue, Cranston, RI 02910 USA
Phone: 401.461.1200 Fax: 401.941.5310
Email:
Web Site: http://www.leonardvalve.com
°F
°C
0
60
140
100
L EONARD
60
20
0
10
30
80
40
R
ASSE
1017
C
THERMOSTATIC
H
LEONARD
1017
ASSE
C
H
THERMOSTATIC
LE ONARD
20
40
50
-10
120
30
20
100
20
40
140
0
°F
50
-10
60
°C
LEONARD
10
0
R
120
40
80
60
COLD INLET
DOMESTIC OUTLET
HOT INLET
DOMESTIC OUTLET
COLD INLET
HOT INLET
4. Flush pipes thoroughly after system has been
connected.
5. If this assembly is installed on a recirculated hot water
system it
MUST
be piped according to
LEONARD’S
REQUIRED PIPING METHODS
(see pages 4 & 5).
6. Refer to page 3 of this bulletin for correct Setup
Instructions.
1. Type TM manifold systems are factory pre- assembled
and tested and include large and small thermostatic water
mixing valves which function as a system to meet both
high and low demand for tempered water.
2. System should be installed at a location where it can
easily be cleaned, adjusted or repaired.
3. System supplies must be connected as shown (Hot-left,
Cold-right). Exercise caution when soldering.
Maximum Operating Pressure 125PSI (860 KPA) for Hot and Cold Water.
CAUTION
All thermostatic water-mixing valves have limitations. They will not provide the desired
accuracy outside of their flow capacity range. Consult the capacity chart on page 8. Minimum
flow must be no less than as shown.
