Leonard LMS-188-4P-BMS, Руководство по эксплуатации

Страница: 12 / 15

11
IV Operation
When the unit is monitoring there are no LEDs lit, pressing RESET will
light the green LED to indicate OK.
• A flashing yellow light indicates that an alarm condition is being timed.
• A flashing red light means that an alarm condition has persisted for the
set time and has been transmitted to the monitoring device, this LED
will continue to flash even if the alarm condition has corrected itself.
• Pressing
RESET will cause the red LED to stop flashing and reset the
output contacts to their normal non-alarm state, if the alarm condition
persists the yellow LED will again flash to indicate timing and, after
timing out, will light the red LED and change the output contacts.
NOTE It is important that the battery condition be checked regularly by pressing
RESET . A dead battery may prevent proper operation of the Alarm Delay
Module.
This is the hookup from a relay (contact) output of an LMS-188-4P-BMS, or other
device,
to the RDU.
Use the slide switch on the main board to choose N.O. or N.C. input.
On the output side, the RDU offers Normally Open (4, 5) or Normally Closed (3, 4)
contacts, and may be connected to a dialer, beeper, strobe light, etc.