7
8
6. Disc Brake Installation
If you use disc brakes on your bike, please follow the instructions on figure 6.1 and 6.2.
If you are using a rim brake, you can ignore the instructions on figure 6.1 and 6.2.
* The tools you may need: 4mm hex key.
5. Assembly of Handlebar Components
Remove the existing handles and brake levers. Then mount the display (left), the thumb throttle
lever (right) and the brake levers and handles. The installation may vary depending on the type of
handlebar, so the illustration is an example.
* The tools you may need: 75*4mm screwdriver (for display), 5mm hex key (for brake lever).
Connect all cables as shown in the image below. Ensure that the correct cables connect the
controller to the motor, display and PAS sensor.
Remove screws and shim from motor.
Using the bolts from the previous front
motor wheel (without seal)
Remove the disc brake from your previous
front wheel and mount them including the
screws on your new motor wheel.
(6.1)
(6.2)
6
