Lenze 2141, Руководство по эксплуатации, Страница: 24 / 90

Parameter setting
6-2
L
BA2141 EN 1.0
6.1 Parameter data channel configuration
6.1.1 Parameter data
Parameter data are addressed through Lenze codes. You find a code table in the Operating
Instructions for your controller.
Lenze parameter sets
Parameter sets are for special code saving which is necessary because of different configurations
for different application processes.
The following table informs about the number of parameter sets and how to address them.
82XX 8200 vector
93XX
82XX and 8200 vector controllers have 2 and 4 parameter sets. They can be directly addressed
through LON.
They are addressed by means of a code-digit offset:
93XX controllers have 4 parameter sets
(depending on the variant) for non-volatile
saving.
Another parameter set is in the ser
•
Offset 0 addesses parameter set 1 with Lenze codes C0000 to C1999
•
Offset 2000 addresses parameter set 2 with Lenze codes C2000 to C3999
Another parameter set is in the user
memory of the controller. This is the
current parameter set
No additional parameter sets available.
•
Offset 4000 addresses parameter set 3 with the
Lenze codes C4000 to C5999
•
Offset 6000 addresses parameter set 4 with the
Lenze codes C6000 to C7999
current parameter set.
After switching on the controller,
parameter set 1 is automatically loaded
into the current parameter set.
Changes of the current parameter set will
If a parameter is available only once (see Operating Instructions for 82XX or 8200 vector), use the
code digit offset 0.
Changes of the current parameter set will
be lost after switching off the controller.
The current parameter set is stored in
d C0003
Example for C0011 (maximum field frequency):
C0011 in parameter set 1: Lenze code = 11
C0011 in parameter set 2: Lenze code = 2011
p
code C0003.
Only the current parameter set can be
directly addressed through LON.
The 93XX codes are listed in the
-
C0011 in parameter set 3: Lenze code = 4011
C0011 in parameter set 4: Lenze code = 6011
The 93XX codes are listed in the
Operating Instructions and the Manual.
Parameter changes
Automatic saving in the controller
Automatic saving (can be switched off under C0003) Changes must be saved in code C0003.
All changes made without storing them will
be lost after the controller is switched off.
Process data changes
No automatic saving
No automatic saving No automatic saving
Stop!
•
For 8200 vector
– Please note that it is not allowed to write parameter data to the EEPROM.
– If you want to cyclically change parameter data, the code must be configured as follows
after every mains switching: C0003 = 0.
•
For 82XX
– Please note that it is not allowed to cyclically write parameter data to the EEPROM.
Show/Hide Bookmarks