Information LI101F
Page 7
Figure 1: The program window
(The information shown in the area “Lenz Central Unit information“ may differ
from the above-shown illustration, depending on the command station used and
its software version.)
In the upper part "Lenz Central Unit information" the first line shows the
software version of the command station and the second line displays its
identification. This identification indicates which command station (LZ100,
LZV100, SET02 or Compact) is used. This information will be displayed
accordingly.
In the lower part "LI101F Information" the first line shows the version and
service number of the LI101F. Underneath you will find the set XpressNet
address and the baud rate. These settings can be altered with the LI101F
Tool.
The set COM port is shown at the bottom left of the program window. Next
to it you will find the button which you can use to start the reading-out
process of the information of the interface and the command station. Use
the "Quit" button on the extreme right to terminate the program.
If the areas "Lenz Central Unit information" and "LI101F Information" show
the information displayed in Figure 1, the LI101 has been connected
correctly and the PC is able to communicate with the
Digital plus by Lenz ® system via the LI101F. The information shown in
the area "Lenz Central Unit information" may differ from the above-shown
illustration, depending on the command station used and its software
version.
