BASE ASSEMBLY:
FAN HEAD/CONTROLLER ASSEMBLY:
1. Loose the two thumbscrews located at the back of the fan head/controller.
• Do not fully unscrew- the two nuts will fall off.
2. Locate the two holes underneath the fan head /controller. Assemble the two tubes and
push down until it stops.
3. Tighten the two Thumb Screws.
FAN BLADE AND SAFETY GRID ASSEMBLY:
1. Place the rear grid on the fan head, ensuring the wire handle on the back of the grid is at
the top.
2. Screw the plastic nut to secure the grid.
3. Place the fan blade onto the motor spindle.
4. Fix the blade into place by gently tightening the spinner anticlockwise onto the end of the
motor spindle. The spinner nut is self-tightening when the motor starts - so do not force it.
5. Place the front grid into position and secure it by closing the secure clips. The screw and
nut at the bottom of the grille must be fitted.
ATTENTION!
• Do not operate the fan until the safe grills and blade properly installed.
MIST GENERATOR AND WATER TANK
1. Place the misting generator onto the base, ensuring it is seated properly in its recess.
2. Place the water tank on top of the misting generator. Fit the cover to the top of the water
tank.
3. Push the end of the flexible hose into the hole at the top of the water tank cover and
push in as far as you can. Do not kink the hose.
1. Put the plastic cover on the weighted
base.
2. Remove the screws from the ends. Insert
the two supporting tube ends into the plate
holes.
3. Fit the washers and replace the two
screws to fix the supporting tubes.
