THERMAL CUT-OUT:
The appliance is fitted with a thermal cut-out. If this is activated, the unit will turn
itself off, although the lamp with remain on.
The unit must be unplugged
before it can be reset.
To reset the appliance, wait until the unit has cooled
down. The reset button is located on the underside of the appliance.
This safety device may have been switched off during transport, if so reset the
thermal cut-off following the above instructions.
If resetting this thermal cut-out does not switch the unit back on, please contact
the manufacturer.
CLEANING THE APPLIANCE:
This unit must be cleaned thoroughly after each use. This is in addition to a
weekly cleaning using vinegar to remove mineral deposits. If these deposits are
not removed, pitting of the metal can occur and may result in damage to the
appliance.
CLEANING AFTER USE:
x
Clean the tank, top cover and the body, etc. and dry them with a soft dry
cloth. All these parts are made of stainless steel and can be cleaned with
a scouring agent.
x
If the appliance is to function properly, the cavity in the middle of the base
must be free of lime scale. Use a scale remover if necessary.
x
This heater includes an overheat protection system that turns off the
heater when parts of the unit are getting excessively hot.
x
To clean the tap, move a brush up and down through the tap, then insert
the brush through opening inside the appliance to clean the tap
connection.
x
Wash the tap handle in hot soapy water and rinse. Replace the tap.
x
Do not use baking soda to clean the appliance as it can discolor and pit
the metal.
USAGE PARAMETERS:
Model Power Volume Voltage
Temperature
Humidity
UR10 2000W 10L
220-240V/50Hz 10-38 degrees
Less than 90%
