Use and controls:
1. Before using the heater, make sure that it is on a flat and stable surface, damage
may occur if it is placed on an incline or decline.
2. Set all the controls to OFF position and insert the plug into a power outlet.
3. Rotate the thermostat knob clockwise to MAX position and switch the heater on as
follow: the switch I for low heat, the switch II for medium heat and both switches on
for high heat.
4. When your room reaches the desired temperature, now slowly rotate the
thermostat knob counterclockwise until the pilot light goes out. The thermostat can
now be left at this setting. As soon as the room temperature has dropped below the
set temperature, the unit will switch itself on automatically until the set temperature
has been reached again. In this way the room temperature remains constant with the
most economical use of electricity.
5. If you want to change the room temperature setting, rotate the thermostat knob
clockwise to raise the temperature, or counterclockwise to lower it.
6. This heater includes an overheat protection system that shuts off the heater when
parts of the heater are getting excessively hot.
7. To completely shut the heater off, turn all the controls to OFF, and remove plug
from the power outlet.
Cleaning and maintenance:
1. Always remove the plug from the power outlet and allow the heater to cool down
before cleaning it.
2. Wipe heater with a soft damp (not wet) cloth.
3. To store away the heater, wind the cable round bobbin and store the heater in a
clean dry place.
WARNING:
Do not immerse the heater in water.
Do not use any cleaning chemicals such as detergents and abrasives.
Do not allow the interior to get wet as this could create a hazard.
