Lenovo ThinkVision L190, Руководство пользователя

Страница: 16 / 32

14
When you first use your monitor, you must perform Auto Setup for analog
input. This procedure sets up your monitor to process the video signals
from your computer without image discoloration or smearing. After you
perform Auto Setup, the settings are stored and used each time you turn on
the monitor.
In order to optimize the displayed image a set-up utility is provided on the
Lenovo
User’s Guide and Installation Files CD . Operation of this utility is
dependent on the operating system on your computer. You may choose to
run Image setup for each operating system that you use. This means that if
you sometimes use your monitor while running any version of Windows and
sometimes also use it from within DOS (not a DOS window), you must run
Image setup for both Windows and DOS. You may run versions of Image
setup in any order.
Before you begin Image setup for your computer, make sure the
computer video mode is set in the range of the supported screen
resolution shown in the table on page 22.
You should perform Image setup for each screen mode you use.
Automatic Image setup
Image setup
Before carrying out this
section, it is very important
that the correct monitor
drivers have been installed.
(See pages 11 and 13. )
i
The Setup Utility included
on the setup CD displays a
test pattern of dots. It does not
replace or modify the display
drivers.
i The Image setup
instructions require the
monitor to be warmed up for 15
minutes. This is not required
for normal operation.
i
If your computer does not
run with the setup CD
shipped with the monitor, refer
to Manual Image setup on
page 17.
i The Image setup process
only applies to the current
screen mode. When a new
mode is selected, repeat this
section to reset the monitor.