- 4 -
ThinkSystem RAID 930-24i Adapter Installation and User Guide
1st Edition
Chapter 1: Hardware Installation
Hardware Installation Instructions
Figure 1 Installing the ThinkSystem RAID 930-24i Adapter in a PCIe Slot
5.
Connect SAS cables between the adapter and the SAS backplane or any other SATA device or SAS device.
The ThinkSystem RAID 930-24i adapter has six SFF-8643, internal x4, mini-SAS HD connectors. Use cables with an
external or internal mini-SAS HD connector on one end to connect to the adapter and the appropriate connector
on the other end to attach to the backplane or the SAS/SATA devices. Connectors must be cabled to specific drive
slots, as shown in the following table.
NOTE
See
Section 2.5.1, Board Layout, LEDs, Jumpers, and Connectors
for
more information about the connectors for your adapter.
6.
Replace the cover and reconnect any cords and cables, and power up the system.
Replace the chassis’s cover,
reconnect any power cords, and reconnect any network cables. Turn on the power.
7.
Run the Human Interface Infrastructure (HII) Configuration Utility
Run the HII Configuration Utility to make any desired configuration changes. Refer to the
ThinkSystem Storage
Adapter Software User Guide
for detailed steps on drive configuration.
The hardware installation of your adapter is complete.
Connector
Drive Slots
C0
Drive slot 0-3
C1
Drive slot 4-7
C2
Drive slot 8-11
C3
Drive slot 12-15
C4
Drive slot 16-19
C5
Drive slot 20-23
3_03804
Edge of
Motherboard
Press
Here
PCIe Slot
Bracket
Screw
Press
Here
Содержание ThinkSystem RAID 930-24i
Страница 1: ...7KLQN6 VWHP 5 L GDSWHU QVWDOODWLRQ DQG 8VHU XLGH ...
Страница 24: ......
