Lenovo ThinkSystem NE2552E, Инструкция по применению

Страница: 381 / 574

© Copyright Lenovo 2018 Chapter 27: Border Gateway Protocol
381
Aggregating Routes
Aggregation is the process of combining several different routes in such a way that
a single route can be advertised, which minimizes the size of the routing table. You
can configure aggregate routes in BGP either by redistributing an aggregate route
into BGP or by creating an aggregate entry in the BGP routing table.
To define an aggregate route in the BGP routing table, use the following
commands:
An example of creating a BGP aggregate route is shown in “Default Redistribution
and Route Aggregation Example” on page 386 .
Redistributing Routes
In addition to running multiple routing protocols simultaneously, Lenovo ENOS
software can redistribute information from one routing protocol to another. For
example, you can instruct the switch to use BGP to re ‐ advertise static routes. This
applies to all of the IP ‐ based routing protocols.
You can also conditionally control the redistribution of routes between routing
domains by defining a method known as route maps between the two domains.
For more information on route maps, see “What is a Route Map?” on page 378 .
Redistributing routes is another way of providing policy control over whether to
export OSPF routes, fixed routes, and static routes. For an example configuration,
see “Default Redistribution and Route Aggregation Example” on page 386 .
Default routes can be configured using the following methods:

Import
 Originate—The router sends a default route to peers if it does not have any
default routes in its routing table.
 Redistribute—Default routes are either configured through the default gateway
or learned via other protocols and redistributed to peer routers. If the default
routes are from the default gateway, enable the static routes because default
routes from the default gateway are static routes. Similarly, if the routes are
learned from another routing protocol, make sure you enable that protocol for
redistribution.
 None
NE2552E(config)# router bgp
NE2552E(config-router-bgp)# aggregate-address
<1 ‐ 16> <IPv4 address> <mask>
NE2552E(config-router-bgp)# aggregate-address
<1 ‐ 16>
enable
NE2552E(config-router-bgp)# exit