Lenovo ThinkSystem NE1032T, Руководство по установке

Страница: 62 / 120

62
NE1032T Installation Guide
To remove a hot ‐ swap power supply module, complete the following steps:
1.
Remove the power cord from the module’s power connector.
2.
Press the release latch of the power supply module, and slide the module out of the
bay.
Attention: Do not leave the power ‐ supply bay empty for more than 90 seconds
while the switch is operating. Either replace the power supply module or install a
blank power filler plate.
To return the component to customer service for replacement, see Appendix A,
“Getting Help and Technical Assistance“ to help you gather all the required
information that is necessary to return a component. After you remove the
component, securely pack the component for shipping.
Replacing the Power Supply Module
Statement 31
DANGER
Electrical current from power, telephone, and communication cables is
hazardous.
To avoid a shock hazard:
 Do not connect or disconnect any cables or perform installation,
maintenance, or reconfiguration of this product during an electrical storm.
 Connect all power cords to a properly wired and grounded power source.
 Connect to properly wired power sources any equipment that will be
attached to this product.
 When possible, use one hand only to connect or disconnect signal cables.
 Never turn on any equipment when there is evidence of fire, water, or
structural damage.
 Disconnect the attached ac power cords, dc power sources, network
connections, telecommunications systems, and serial cables before you
open the device covers, unless instructed otherwise in the installation and
configuration procedures.
 Connect and disconnect cables as described in the following table when
you install, move, or open covers on this product or attached devices.